Emergency Boarding Up

Guide · Homeowners · 4 min read · Updated 17 November 2026

How to Make a Broken Window Safe Until It Can Be Replaced

Short answer

To make a broken window safe, keep people and pets away, wear thick gloves and eye protection, and remove only loose shards you can reach from the ground. Tape cracked glass to stop it falling, then cover the opening with exterior-grade plywood screwed to the frame. Leave upper-floor windows, large panes and shopfronts to a boarding team, which typically costs £120–£220 for one window in the daytime.

How to Make a Broken Window Safe Until It Can Be Replaced

Protect people first

Broken glass causes serious cuts, and the danger is not just at the window. When a pane is smashed by a stone or a burglar, fragments can travel several metres across a room and hide in carpets, rugs and soft furnishings. Shut the room if you can and keep children and pets out until it has been cleared. Outside, cordon off the area under the window with bins or garden furniture so nobody walks through it.

Do not try to deal with glass that is still hanging high in a frame above head height. A large piece that falls from an upstairs window can cause a fatal injury. If a big pane is cracked but intact, apply strips of strong tape across it in a grid to hold it together while you wait for help.

  • Keep children and pets out of the room and away from the outside area.
  • Wear thick gloves, eye protection and sturdy shoes.
  • Tape cracked panes in a grid to hold them together.
  • Never work below loose glass hanging overhead.

Clearing glass safely

If the window is at ground level and you feel confident, remove loose pieces from the frame by working from the top down, so that nothing above falls onto your hands. Lift pieces out rather than pulling them sideways. Wrap shards in thick newspaper or cardboard and put them in a sturdy box, labelled as broken glass, before they go in any bin.

Toughened glass behaves differently from ordinary float glass. It breaks into small rounded cubes that are less likely to cause deep cuts but spread widely, so vacuum thoroughly. Laminated glass cracks but stays in place on its inner film, and usually has to be cut out with a knife. If you are not sure what kind of glass it is, leave it to a professional.

Temporary covers you can fit yourself

For a small ground-floor window, the most effective DIY cover is a sheet of exterior-grade plywood cut slightly larger than the opening and screwed to the outside of the frame, or fitted inside the reveal. Screws hold better than nails and are easier to remove later without damaging the frame further. Heavy-duty polythene sheet stapled or taped over the opening keeps the weather out but provides no security, so it is only suitable for a short time in an occupied home.

Cardboard and tape will stop draughts for a night but will not keep anyone out. If the window is the way an intruder got in, or the property will be empty, proper boarding is needed the same day.

Temporary coverWeatherproofSecureSuitable for
Exterior-grade plywoodYesYes, if well fixedGround-floor windows, days to weeks
Clear polycarbonateYesYes, if well fixedRooms that need light
Heavy polythene sheetPartlyNoOne night in an occupied home
Cardboard and tapeNoNoVery short term only

When to call a boarding team

Call a professional for any window above ground floor, any pane larger than you can handle safely, laminated or double-glazed units that need cutting out, shop windows and glazed doors, and any break-in where security matters. A boarding operative brings sheets, fixings, access equipment and the tools to clear glass safely, and leaves an itemised invoice that most insurers will accept after an insured event.

Daytime boarding of a single domestic window typically costs £120–£220, with out-of-hours attendance at £180–£350 and additional windows on the same visit at £50–£120 each. If the glass has to stay out for more than a few days and you need light, ask for polycarbonate temporary glazing instead of plywood.

Getting the permanent glass fitted

Once the opening is secure, arrange a glazier. Single panes in older frames can often be cut and fitted quickly, while sealed double-glazed units are made to measure and may take a week or more. In England and Wales, glass in critical locations, such as doors, panels beside doors and low-level glazing, must meet the safety requirements of Approved Document K, so ask for toughened or laminated glass where it is required.

If the window was broken in a break-in, consider laminated glass for the replacement. It stays in the frame when struck, which makes forced entry slower and noisier. Keep the boarding invoice, glazing invoice and photographs together for your insurer.

Common mistakes to avoid

The most common mistake is trying to pull large pieces of glass out of a frame by hand, which is how many deep cuts to hands and wrists happen. The second is working from a ladder while handling glass or a heavy sheet of plywood, when both hands are needed and a slip can mean a fall onto broken glass. If the job needs a ladder, it is a job for someone with proper access equipment and a second person.

Other mistakes are quieter but still costly. Throwing loose glass into a bin bag can injure whoever handles it next. Nailing a sheet straight through a uPVC frame can crack the profile and add to the repair bill. Leaving a broken window covered only with polythene in an empty house overnight risks a second break-in. And clearing everything before taking photographs can weaken an insurance claim, so record the damage first.

Questions people also ask

Can I leave a broken double-glazed window until morning?

If only the outer pane of a sealed unit is cracked and the inner pane is intact, the window is still weathertight and secure, so it can usually wait for a glazier. If the whole unit is broken through, the opening needs covering the same day, especially on the ground floor or in an empty property.

What tape should I use on cracked glass?

Strong duct tape or wide parcel tape applied in a criss-cross pattern across the whole pane helps hold cracked glass together and reduces the chance of pieces falling. It is only a temporary measure. Do not press hard on badly cracked glass while applying it, and wear gloves and eye protection.

How do I dispose of broken glass at home?

Wrap pieces in thick newspaper or cardboard, put them in a sturdy box, tape it shut and label it clearly as broken glass, so bin collectors are not injured. Check your council's guidance, as some prefer large amounts to go to a household waste recycling centre. Window glass is not usually accepted in bottle banks.

Written and checked by the Emergency Boarding Up team. Read our editorial policy.

Get a free emergency boarding up quote

Tell us what you need and we'll come back with a clear price.

Request a quote